2021 Hyundai Venue SEFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Shift the gear to "N".
  2. Remove the air cleaner and air duct.
    1. Remove the air duct (A).
      G14694836Courtesy of HYUNDAI MOTOR AMERICA
    2. Disconnect the breather hose (B) and air intake hose (C).
    3. Remove the air cleaner assembly (D).

      Tightening torque: 

      Hose clamp bolt (C):

      2.9 - 4.9 N.m (0.3 - 0.5 kgf.m, 2.1 - 3.6 lb-ft)

      Air cleaner assembly bolts (D):

      3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb-ft)

      G14694837Courtesy of HYUNDAI MOTOR AMERICA
  3. Disconnect the position switch connector (A) and then loosening the shift cable mounting nut (B).
    G14694838Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the manual control lever (A) and the washer after removing a nut.
    G14694839Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the position switch (A) after removing the bolts.
    G14694840Courtesy of HYUNDAI MOTOR AMERICA
Chapter Navigation
Return to Chapter: Repair Procedures
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.