Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Hyundai Venue SEFACTORY OEM SERVICE PROCEDURE
Automatic Transaxle System DTCS
AUTOMATIC TRANSAXLE SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| P0601-00 | Internal Control Module Memory Check Sum Error |
| P0705-12 | Transmission Range Sensor Circuit Malfunction (PRNDL Input) |
| P0705-14 | Transmission Range Sensor Circuit Malfunction (PRNDL Input) |
| P0705-1C | Transmission Range Sensor Circuit Malfunction (PRNDL Input) |
| P0706-61 | Transmission Range Sensor Circuit Range/Performance |
| P0706-96 | Transmission Range Sensor Circuit Range/Performance |
| P0711-00 | Transmission Fluid Temperature Sensor 'A' Circuit Range/Performance |
| P0712-00 | Transmission Fluid Temperature Sensor 'A' Circuit Low Input |
| P0713-00 | Transmission Fluid Temperature Sensor 'A' Circuit High Input |
| P0717-00 | Input/Turbine Speed Sensor 'A' Circuit No Signal |
| P0721-00 | Secondary Pulley Speed Sensor Circuit Range/Performance |
| P0722-00 | Secondary Pulley Speed Sensor Circuit No Signal |
| P0730-00 | Incorrect Gear Ratio |
| P0731-00 | Gear 1 Incorrect Ratio |
| P0741-00 | Torque Converter Clutch Solenoid Valve Stuck Off |
| P0743-00 | Torque Converter Clutch Solenoid Valve Electrical |
| P0748-00 | Pressure Control Solenoid 'A' Electrical (Line Pressure) |
| P0758-00 | Shift Control Solenoid Valve 'B' (Clutch) Electrical |
| P0778-00 | Pressure Control Solenoid 'B' Electrical (Primary Pulley) |
| P0791-00 | Primary pulley Speed Sensor Circuit |
| P0798-00 | Pressure Control Solenoid 'C' Electrical (Secondary Pulley) |
| P0845-00 | Transmission Fluid Pressure Sensor/Switch 'B' Circuit |
| P0846-00 | Transmission Fluid Pressure Sensor/Switch B Circuit Range/Performance |
| P0867-00 | Transmission Fluid Pressure |
| P0867-F0 | Transmission Fluid Pressure |
| P0867-F1 | Transmission Fluid Pressure |
| P0880-00 | TCM Power Input Signal |
| P0955-00 | Auto Shift Manual Mode Circuit |
| P1602-00 | CVT No Learning & No EOL Data |
| U0001-00 | High Speed CAN Communication Bus |
| U0100-00 | Lost Communication with ECM/PCM 'A' |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.