Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Hyundai Veloster TurboFACTORY OEM SERVICE PROCEDURE
Heated Steering Wheel Control Module (Body Control Module (BCM)
- Turn the ignition switch OFF and disconnect the battery negative (-) cable.
- Remove the glove box upper cover.
(Refer to Body - "GLOVE BOX UPPER COVER ")
- Remove the smart key unit.
(Refer to Body Electrical System - "SMART KEY UNIT ")
- Remove the body control module (A) after removing the bolt and nut.
- Disconnect the body control module connector (A).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.