Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Repair Procedures: Replacement
- Remove the rear wheel hub bearing assembly. (Refer to REAR HUB - CARRIER )
- Fix the rear hub bearing assembly (A) on the vise.NOTE: When fixing on the vise, use a cloth so not to damage the hub bearing assembly.
Be careful if excessive force for fixing on the vise may damage the hub bearing assembly.
- Check the direction of the sensor cap (A).
- Remove the sensor cap by hammering on a gap between sensor cap and hub bearing assembly using a scraper (A).
- Check if there is distortion or damage to the tone wheel encoder (A).
- Position the sensor cap to the same direction of sensor cap (A) as you check before removing.
- Install the sensor cap (A) with the special service tool (09527AL200).NOTE: Hammer until there is no gap between the SST and hub bearing assembly and install the sensor cap.
Be careful not to tilt to one side when installing the sensor cap as it may damage the tone wheel or encoder.
When installing sensor cap, hammer it until the gap closes between the sensor cap and hub bearing assembly.
- Install the rear wheel hub bearing assembly. (Refer to REAR HUB - CARRIER )
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
