2021 Hyundai Veloster TurboFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Turn the ignition switch OFF and then disconnect the negative (-) battery cable.
  2. Separate the intercooler inlet hose (A) from the turbocharger and then remove the inter cooler inlet pipe (B). [Gasoline 1.6]

    Tightening torque 

    Clamp: 4.9 - 6.9 N.m (0.5 - 0.7 kgf.m, 3.6 - 5.1 lb-ft)

    Mounting bolt: 18.6 - 23.5 N.m (1.9 - 2.4 kgf.m, 13.7 - 17.4 lb-ft)

    G13053512Courtesy of HYUNDAI MOTOR AMERICA
  3. Pull up the lock of the HECU connector and then disconnect the connector (A).
    G13053513Courtesy of HYUNDAI MOTOR AMERICA
  4. Separate the brake tubes from the HECU by unlocking the nuts (6-ea) counterclockwise using a spanner.

    Tightening torque: 

    12.7 - 16.7 N.m (1.3 - 1.7 kgf.m, 9.4 - 12.3 lb-ft)

    G13053514Courtesy of HYUNDAI MOTOR AMERICA

    Tightening torque: 

    18.6 - 22.5 N.m (1.9 - 2.3 kgf.m, 13.7 - 16.6 lb-ft)

    G13053515Courtesy of HYUNDAI MOTOR AMERICA
  5. Loosen the ABS control module mounting bolt, nut (A) from the vehicle.

    Tightening torque: 

    12.7 - 16.7 N.m (1.3 - 1.7 kgf.m, 9.4 - 12.3 lb-ft)

    G13053516Courtesy of HYUNDAI MOTOR AMERICA
  6. Separate the bracket (B) after remove the mounting bolt from the HECU (A).
    G13053517Courtesy of HYUNDAI MOTOR AMERICA
    NOTE:
    • Never attempt to disassemble the ABS.
    • The HECU must be transported and stored in.
    • Never shock to the ABS.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.