2021 Hyundai Veloster N Standard TransFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Turn OFF ignition switch and disconnect the negative (-) battery cable.
  2. Remove the shift lever knob & boots (A) pull both of it up.
    G15472369Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the floor console assembly. (Refer to Body - "FLOOR CONSOLE ")
  4. Remove the snap pin (A).
    G15472370Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the clip, in the shape of a "U" (B), from the cable end by spreading it towards both sides.
    G15472371Courtesy of HYUNDAI MOTOR AMERICA
  6. Disconnect the shift cable (A).
  7. Disconnect the select cable (B).
    G15472372Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the shift lever assembly (A) after removing the bolts.

    Tightening torque:Β 

    8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb-ft)

    G15472373Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.