Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Hyundai Veloster N Standard TransFACTORY OEM SERVICE PROCEDURE
Repair Procedures: Removal
- Turn OFF ignition switch and disconnect the negative (-) battery cable.
- Move the shift lever to 4th gear.
- Remove the air cleaner assembly and air duct. (Refer to Engine Mechanical System - "AIR CLEANER ")
- Remove the battery and battery tray. (Refer to Engine Electrical System - "BATTERY ")
- Remove the engine control module (ECM). (Refer to Engine Control System - "ECM ")
- Remove the snap pin (A).
- Disconnect the shift cable (B) and the select cable (C) from the bracket.
- Remove the shift lever knob & boots (A) pull both of it up.
- Remove the floor console assembly. (Refer to Body - "FLOOR CONSOLE ")
- Remove the snap pin (A).
- Remove the clip, in the shape of a "U" (B), from the cable end by spreading it towards both sides.
- Disconnect the shift cable (A).
- Disconnect the select cable (B).
- Remove the retainer (A) after removing the nut (B-2ea).
- Remove the control cable assembly from the vehicle.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.