Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
e-CVVT Relay
The CVVT (Continuously Variable Valve Timing) system is installed to the chain sprocket of the camshafts. This system controls the camshaft to provide optimal valve timing. Electric Continuously Variable Valve Timing (e-CVVT) which is consisted of DC motor, warm gear and position sensor is installed at intake camshaft to control valve timing of intake.
The CVVT controller at exhaust camshaft regulates the camshaft angle using oil pressure through the OCV.
The ECM controls e-CVVT at intake and CVVT at exhaust to obtain optimized valve timing according to the signals output from air flow, throttle position and engine coolant temperature. As result, the relative position between the camshaft and the crankshaft becomes optimal and the engine torque improves, fuel economy improves, exhaust emissions decrease under overall driving conditions. Also, the ECM can control valve timing at cold start and at a time of start with e-CVVT.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
