2021 Hyundai Veloster N Standard TransFACTORY OEM SERVICE PROCEDURE

Boost Pressure Sensor (2nd T-MAP, PUT)

G15152135Courtesy of HYUNDAI MOTOR AMERICA

The Boost Pressure Sensor (BPS) is located in the intake air tube between the turbocharger inter cooler and the throttle body. The BPS measures the throttle inlet pressure. The ECM uses the information from the BPS to refine the estimate of the airflow rate through the throttle and to determine the desired boost pressure. The BPS for a speed density system is integrated with the turbocharger inter cooler temperature sensor. The turbocharger waste gate regulating valve solenoid allows the ECM to control the turbocharger waste gate position. The turbocharger waste gate regulating valve solenoid controls the pressure or vacuum supplied to the pneumatically actuated waste gate diaphragm in order to control the boost pressure limit. When the compressor outlet pressure increases, a pneumatically powered actuator opens the turbocharger waste gate and limits the compressor outlet pressure.

The turbocharger waste gate regulating valve solenoid supplies pressure or vacuum to the pneumatically actuated waste gate canister diaphragm, which regulates the boost pressure to the desired value.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.