Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Hyundai Veloster N Standard TransFACTORY OEM SERVICE PROCEDURE
Repair Procedures: Removal
- Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")
- Remove the rear seat cushion. (Refer to Body - "REAR SEAT ASSEMBLY ")
- Remove the fuel pump service cover (A).
- Disconnect the fuel pump control module connector (A) and the fuel tank pressure sensor connector (C).
- Disconnect the fuel feed tube quick connector (B) and the fuel pressure connector (D).
- Remove the fuel pump from the fuel tank after removing the fuel pump plate cover (A).
- Remove the fuel pump from the fuel tank.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.