2021 Hyundai Veloster N Standard TransFACTORY OEM SERVICE PROCEDURE

Charging System: Alternator: Specifications: Specification

Item Specification
Nominal output 13.5V, 150A
Speed in use 1, 500 - 18, 000 RPM
Voltage regulator IC Regulator built in type
Regulator Setting Voltage External mode Refer to below graph
Internal mode 14.55 ± 0.3V
Temperature Gradient External mode 0 ± 3 mV/°C
Internal mode -3.5 ± 2 mV/°C
Target voltage data (COM) Frequency (Hz) 115 - 500
Signal type PWM
Voltage level (V) High: 3.5 ±0.2
Low: 1.5 ±0.2
Electric load (FR) Frequency (Hz) 250 ± 38
Signal type PWM
Current limitation from vehicle (mA) 2.7 - 7.0
Pulley type OAD
G15471836Courtesy of HYUNDAI MOTOR AMERICA
  • Regulator Setting Voltage (External mode)
G15471837Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.