2021 Hyundai Veloster N Automatic DCT TransFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Make sure vehicle does not roll before setting shift lever to "N" position.
  2. Remove the air cleaner assembly and air duct.

    (Refer to Engine Mechanical System - "AIR CLEANER ")

  3. Remove the battery and battery tray.

    (Refer to Engine Electrical System - "BATTERY ")

  4. Disconnect the position switch connector (A).
    G15474946Courtesy of HYUNDAI MOTOR AMERICA
  5. Loosen the nut and then removing the shift cable (A) and the manual lever (B).
    G15474947Courtesy of HYUNDAI MOTOR AMERICA
  6. Loosen the bolts and then removing the position switch (A).
    G15474948Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.