2021 Hyundai Veloster 2.0, Automatic TransFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Installation

  1. Install the retainer (A) and then tighten the nut (B-2 ea).

    Tightening torque: 

    11.8 - 14.7 N.m (1.2 - 1.5 kgf.m, 8.7 - 10.8 lb-ft)

    G13055977Courtesy of HYUNDAI MOTOR AMERICA
  2. Install the shift cable (B) and then fix the snap pin (A).
    G13055978Courtesy of HYUNDAI MOTOR AMERICA
    CAUTION:
    1. When assembling shift cable, the projection (A) must face upwards.
      G13055979Courtesy of HYUNDAI MOTOR AMERICA
    2. When assembling the snap pin, be careful about the correct direction.
      • The band portion (A) must point to the front of the vehicle.
      • The band portion (A) must point outwards.
      G13055980Courtesy of HYUNDAI MOTOR AMERICA
  3. Install the shift cable (B) in the cable bracket (C).
  4. Align the hole (E) in the manual control lever with the "N" position hole (G) of the inhibitor switch and then insert the inhibitor switch guide pin (SST No: 09480-A3800).
  5. Lightly tighten the nut (A) after connected the shift cable (B) in the manual control lever (D).
  6. Tighten the nut (A) to the specified torque.

    Tightening torque: 

    9.8 - 13.7 N.m (1.0 - 1.4 kgf.m, 7.2 - 10.1 lb-ft)

    G13055981Courtesy of HYUNDAI MOTOR AMERICA
  7. Remove the inhibitor switch guide pin (SST No.: 09480-A3800) from the hole.
  8. Install the heater unit & blower unit

    (Refer to BLOWER UNIT and HEATER UNIT Heating, Ventilation and Air Conditioning - "Heater & Blower")

  9. Install the crash pad lower panel.

    (Refer to Body - "CRASH PAD LOWER PANEL ")

  10. Install the floor console assembly.

    (Refer to Body - "FLOOR CONSOLE ")

  11. Install the battery and tray.

    (Refer to Engine Electrical System - "BATTERY ")

  12. Install the air cleaner assembly and air duct.

    (Refer to Engine Mechanical System - "AIR CLEANER ")

    CAUTION:
    • Check that operating surely at each range of the inhibitor switch corresponding to each position of shift lever.
Chapter Navigation
Return to Chapter: Repair Procedures
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.