2021 Hyundai Tucson Limited, FWDFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Perform the oil pressure characteristics backup procedure using the GDS when replacing with a new TCM.
    G13035264Courtesy of HYUNDAI MOTOR AMERICA
    G13035265Courtesy of HYUNDAI MOTOR AMERICA
    G13035266Courtesy of HYUNDAI MOTOR AMERICA
  2. Turn ignition switch OFF.
  3. Disconnect the negative (-) battery cable.
  4. Remove the air cleaner assembly and air duct.

    (Refer to Engine Mechanical System - "AIR CLEANER ")

  5. Disconnect the TCM connector (A).
    G13035267Courtesy of HYUNDAI MOTOR AMERICA
  6. Disconnect the TCM connector (B).
    G13035268Courtesy of HYUNDAI MOTOR AMERICA
  7. Remove the fixing clip (A) of the wiring.
    G13035269Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the TCM (A) after removing the mounting nuts and bolts (B).

    TCM installation nut:Β 

    9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)

    G13035270Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.