2021 Hyundai Tucson Limited, FWDFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Installation

  1. To install, reverse the removal procedure.
  2. Perform the oil pressure characteristics input procedure using the GDS when replacing with a new TCM.
    G13035271Courtesy of HYUNDAI MOTOR AMERICA
    G13035272Courtesy of HYUNDAI MOTOR AMERICA
    G13035273Courtesy of HYUNDAI MOTOR AMERICA
  3. Perform the procedures related in the ECM after replacing the TCM.

    (Refer to Engine Control/Fuel System - "ENGINE CONTROL MODULE ")

  4. Perform TCM learning after replacing the transaxle to prevent slow transaxle response, jerky acceleration and jerky startup.

    (Refer to Automatic Transaxle Control System - "REPAIR PROCEDURESΒ ")

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.