2021 Hyundai Sonata SEFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Disconnect the battery negative (-) terminal.
  2. Open the cap and then remove the accelerator pedal module (A) after loosening the mounting bolt.

    Tightening Torque:Β 

    8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb-ft)

    G14629225Courtesy of HYUNDAI MOTOR AMERICA
  3. Disconnect the accelerator pedal connector (A).
G14629226Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.