2021 Hyundai Sonata LimitedFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Inspection

  1. Switch "OFF" the ignition.
  2. Disconnect the OPS connector.
  3. Measure resistance the OPS terminals.
  4. Check that the resistance is within the specification.
    Terminal Sensor Resistance (kΞ©)
    2 - 4 2.76 - 4.13
    2 - 3 1.89 - 2.84
    3 - 4 1.71 - 2.84
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.