2021 Hyundai Sonata LimitedFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

Information 

  • Accelerator Position Sensor (APS) cannot be replaced on its own, it should be replaced with accelerator pedal assembly.
  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Disconnect the accelerator position sensor connector (A).
    G14625727Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the mounting cap (A).
    G14625728Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the accelerator pedal assembly after loosening the mounting bolt & nut (A).

    Tightening Torque: 

    8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb.ft)

    G14625729Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.