2021 Hyundai Santa Fe SE, FWDFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Adjustment

NOTE:
  • Perform the following procedure when replacing ECM (New parts/Reused parts).
  • ECM and TCM are integrated, TCM related procedures should be performed when the ECM is replaced.
  1. Perform the neutral mode using the diagnosis tool when replacing with a reused ECM.

    [Non-Smart Key] 

    G14534156Courtesy of HYUNDAI MOTOR AMERICA

    [Smart Key] 

    G14534157Courtesy of HYUNDAI MOTOR AMERICA
  2. Perform the "KEY TEACHING " procedure by using the diagnosis tool.

    [Non-Smart Key] 

    G14534158Courtesy of HYUNDAI MOTOR AMERICA

    [Smart Key] 

    Turn the ignition switch ON then OFF using the smart key or start button. Then the ECM learns information on the smart key automatically.

  3. Perform the VIN writing procedure by using the diagnosis tool.
    G14534159Courtesy of HYUNDAI MOTOR AMERICA
    G14534160Courtesy of HYUNDAI MOTOR AMERICA
  4. Perform the oil pressure characteristics backup procedure using the diagnosis tool.
    G14534161Courtesy of HYUNDAI MOTOR AMERICA
  5. Perform the ETC module learning procedure.

    (Refer to Engine Control/Fuel System - "ETC System ADJUSTMENT ")

  6. Perform the TCM learning procedure.

    (Refer to Automatic Transaxle Control System - "ADJUSTMENT ")

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.