2021 Hyundai Santa Fe SE, AWDFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Turn the ignition switch OFF and disconnect the battery (-) cable.
  2. Disconnect the mass air flow sensor connector (A) and the installation clamp (B).
  3. Remove the intake hose (C).

    Tightening Torque:Β 

    3.0 - 5.0 N.m (0.3 - 0.5 kgf.m, 2.1 - 3.6 lb-ft)

    G14534165Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the installation bolts (A), and then remove the sensor from the air cleaner.

    Tightening Torque:Β 

    4.0 - 5.8 N.m (0.4 - 0.6 kgf.m, 2.8 - 4.3 lb-ft)

    G14534166Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.