2021 Hyundai Palisade Calligraphy, FWDFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

NOTE:
  • Before removing position sensor, long press the "N" button (A) and position it at the "N".
    G14424356Courtesy of HYUNDAI MOTOR AMERICA
  1. Turn ignition switch OFF and disconnect the negative (-) battery cable.
  2. Remove the battery and battery tray.

    (Refer to Engine Electrical System - "REMOVAL , and BATTERY TRAY ")

  3. Remove the air duct and the air cleaner assembly.

    (Refer to Engine Mechanical System - "AIR CLEANER ")

  4. Disconnect the position sensor connector (A).
  5. Disconnect the electronic shift actuator connector (B).
    G14424357Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the electronic shift actuator (D) after removing the bolts (C).
    G14424358Courtesy of HYUNDAI MOTOR AMERICA
  7. Remove the position sensor (B) after removing the bolts (A).
    G14424359Courtesy of HYUNDAI MOTOR AMERICA
Chapter Navigation
Return to Chapter: Repair Procedures
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.