2021 Hyundai Palisade Calligraphy, FWDFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Release the residual pressure in fuel line.

    (Refer to "RELEASE RESIDUAL PRESSURE IN FUEL LINEΒ ")

  2. Remove the floor carpet service cover (A).
    G14424050Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the fuel pump service cover (A) after loosening the mounting screws.
    G14424051Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the fuel feed tube quick-connector (A) and fuel pressure sensor connector (B) and fuel pump control module (C).
  5. Disconnect the fuel tank pressure sensor connector (D).
    G14424052Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the locking ring (A) by using the special service tool [No.: 09310-B8100].
    NOTE:
    • When removing the plate cover, be careful not to damage the fuel tank and fuel pump.
    • When removing the plate cover, press the upper area with hand and rotate the wrench counter clockwise.
    G14424053Courtesy of HYUNDAI MOTOR AMERICA
  7. Remove the fuel pump from the fuel tank.
    G14424054Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.