Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Hyundai Palisade Calligraphy, FWDFACTORY OEM SERVICE PROCEDURE
Special Service Tools
| Tool Name/Number | Illustration | Description |
|---|---|---|
| Fuel Pressure Gauge 09353-24100 |
Used for measuring the pressure in fuel line | |
| Fuel Pressure Gauge Adapter 0K353-D4100 |
Used for connecting between high pressure fuel pump and low pressure fuel feed tube to measure the pressure in fuel line *SST 09353-C1000 also can be used |
|
| Heated Oxygen Sensor Socket Wrench 09392-1Y100 (19 mm) |
Removal and installation of the heated oxygen sensor * SST No. 09392-2H100 model also can be used for removing the Heated Oxygen Sensor. |
|
| Torque Wrench Socket 09314-3V100 (17 mm) |
Used for removing/installing high pressure fuel pipe | |
| Injector Combustion Seal Guide & Sizing tool 09353-2B000 |
Used for installing injector combustion seal on injector | |
| Injector Remover 09351-D2100 |
Removing the stuck injector | |
| Low Pressure Fuel Pump Plate Cover Remover 09310-B8100 |
Removal and installation of the low pressure fuel pump |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.