Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Hyundai Palisade Calligraphy, FWDFACTORY OEM SERVICE PROCEDURE
Repair Procedures: Removal
WARNING:
- Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift.
(Refer to General Information - "LIFT AND SUPPORT POINTS ")
- Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
- Left the vehicle (Refer to General Information - "LIFT AND SUPPORT POINTS ").
- Disconnect the canister close valve connector (A).
- Disconnect the vent hose quick-connector (A), the vapor hose quick-connector (B) from the canister.
- Remove the canister assembly (A) after loosening the mounting bolt and nut.
- Remove the mounting bolt (A) and then separate the fuel tank air filter (B) from the canister after rotating it in the direction of the arrow shown in the illustrations.
- Release the lever (A) and then separate the canister close valve (B) from the fuel tank air filter by rotating the valve in the direction of the arrow shown in the illustrations below.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.