2021 Hyundai Palisade Calligraphy, FWDFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Turn ignition switch OFF and disconnect the negative (-) battery cable.
  2. In the case of G 3.5L MPI, G 3.8L GDI vehicle, removing the variable intake solenoid (VIS) actuator.

    (Refer to Engine Mechanical System - "VARIABLE INTAKE SOLENOID (VIS) ACTUATOR ")

  3. Pull up the lock of the HECU connector and then disconnect the connector (A).
    G14424691Courtesy of HYUNDAI MOTOR AMERICA
  4. Separate the brake tubes from the HECU by unlocking the nuts (6-ea) counter-clockwise using a spanner.

    Tightening torque:Β 

    13.7 - 16.7 N.m (1.4 - 1.7 kgf.m, 10.1 - 12.3 lb-ft)

    G14424692Courtesy of HYUNDAI MOTOR AMERICA

    Tightening torque:Β 

    18.6 - 22.6 N.m (1.9 - 2.3 kgf.m, 13.7 - 16.6 lb-ft)

    G14424693Courtesy of HYUNDAI MOTOR AMERICA
  5. Loosen the ESP control module mounting nut (A) and then remove the ESP control module from the vehicle.

    Tightening torque:Β 

    16.7 - 25.5 N.m (1.7 - 2.6 kgf.m, 12.3 - 18.8 lb-ft)

    G14424694Courtesy of HYUNDAI MOTOR AMERICA
  6. Separate the bracket (B) after remove the mounting bolt from the HECU (A).
    G14424695Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.