Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Hyundai Ioniq Plug-In Hybrid LimitedFACTORY OEM SERVICE PROCEDURE
Operation For Each Function Of Button Starting
- Electric power ON/Ignition ON
- The electric power is changed through OFF → ACC→IGN→OFF by pressing the button without stepping on the brake (Or with stepping on the brake) inside the car with FOB key (However, repeat ACC↔IGN when it is not in P. Converting to OFF is impossible.)
- The starting is ignited when the button is pressed with stepping on the brake at P/N position with FOB key.
- Electric power OFF/Ignition OFF
- The ignition OFF is possible in the state of vehicle stop. (Ignition OFF is possible in any position of ATM lever.)
- The lever shall be shifted for parking in gear N by pressing the ATM lever release button after electric power off in P.
- How to off the ignition forcibly and to restart during driving
- It is a method of engine stop forcibly in vehicle topping down, fuel leaking and emergency (Ex: Accelerator pedal return failure)
- The engine is off and returned to the ACC state when the button is pressed for 2 seconds and more than 3 times successively within 3 seconds during driving. The restarting is available for next 30 seconds regardless of FOB key and the electric power is changed through OFF → ACC→IGN→OFF by pressing the button without stepping on the brake (or with stepping on the brake) inside the car with FOB key. (However, when it is not in P position, ACC↔IGN is repeated. The conversion to OFF is impossible.)
- Function of 0.5 second delay for brake switch input.
The starting is available when the brake pedal is stepped on within 0.5 second after pressing the start button in engine OFF state.
- State of start button indicator (LED) ON depending on the electric power state.
- Electric power OFF: LED OFF
- Electric power ACC state: Yellow LED ON
- Electric power ON: Blue LED ON
- During cranking: Maintaining the previous LED ON state before cranking
- Starting ON state: LED OFF
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
