2021 Hyundai Accent SE, Standard TransFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Set shift lever to N position.
  2. Turn OFF ignition switch and disconnect the negative (-) battery cable.
  3. Remove the air cleaner assembly and air duct.

    (Refer to Engine Mechanical System - "AIR CLEANER ")

  4. Remove the battery and battery tray.

    (Refer to Engine Electrical System - "BATTERY , and BATTERY TRAY ")

  5. Remove the engine control module (ECM).

    (Refer to Engine Control System - "ENGINE CONTROL MODULE (ECM) ")

  6. Separate the control cable.
    1. Remove the snap pin (A).
    2. Separate the select cable (B) and then shift cable (C).
    G14077209Courtesy of HYUNDAI MOTOR AMERICA
  7. Remove the control shaft assembly (A) after loosening the bolts.

    Tightening torque:Β 

    19.6 - 26.5 N.m (2.0 - 2.7 kgf.m, 14.5 - 19.5 lb-ft)

    G14077210Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.