2021 Hyundai Accent LimitedFACTORY OEM SERVICE PROCEDURE

Component Inspection

  1. Turn the ignition switch "OFF" & Disconnect HO2S (S1) connector.
  2. Measure resistance between heater power and heater control terminal of HO2S (S1) (Component Side)

    Specification: 

    Item Specification
    Heater Resistance (Ω) Approx. 2.5Ω at 20°C (68°F)
  3. Is the measured resistance within specification?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector. Or, ECM memory was not cleared after repair. Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR ".

    NO 

    • Replace the HO2S (S1) with an usable one and check for proper operation. If the problem is corrected, replace the HO2S (S1) and then go to "VERIFICATION OF VEHICLE REPAIR ".
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.