2021 Hyundai Accent LimitedFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Turn the ignition switch OFF and then disconnect the negative (-) battery cable.
  2. Pull up the lock of the HECU connector, then disconnect the connector.
    G14078050Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the brake fluid from the master cylinder reservoir with a syringe.
    NOTE:
    • Be sure to completely remove foreign substances from around brake fluid reservoir and cap before opening the reservoir cap. If not, it may cause contamination of brake fluid and deterioration in braking performance.
    • Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
  4. Disconnect the brake tubes from the HECU by unlocking the nuts counterclockwise with a spanner.

    Tightening torque:Β 

    13.7 - 16.7 N.m (1.4 - 1.7 kgf.m, 10.1 - 12.3 lb-ft)

    G14078051Courtesy of HYUNDAI MOTOR AMERICA

    Tightening torque:Β 

    18.6 - 22.6 N.m (1.9 - 2.3 kgf.m, 13.7 - 16.6 lb-ft)

    G14078052Courtesy of HYUNDAI MOTOR AMERICA
  5. Loosen the HECU bracket bolts (A), then remove HECU and bracket.

    Tightening torque:Β 

    16.7 - 25.5 N.m (1.7 - 2.6 kgf.m, 12.3 - 18.8 lb-ft)

    G14078053Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the 3 bolts, then remove the bracket from HECU.

    Tightening torque:Β 

    7.8 - 9.8 N.m (0.8 - 1.0 kgf.m, 5.8 - 7.2 lb-ft)

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.