2020 Hyundai Elantra Value EditionFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Inspection

WARNING: This page is about a different car, the 2019 Hyundai Elantra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check for resistance between terminals in each switch position (LH).
    G12974991Courtesy of HYUNDAI MOTOR AMERICA

    [LH: Audio + Hands free] 

    Switch Connector Terminal Resistance ±(3%)
    SEEK Up 1 - 6 430Ω
    SEEK Down 1.11 kΩ
    MODE 2.11 kΩ
    MUTE 3.11 kΩ
    Volume (+) 4.61 kΩ
    Volume (-) 6.81 kΩ
    Voice 10.71 kΩ
    SEND 18.91 kΩ
    END 40.91 kΩ
  2. Check for resistance between terminals in each switch position (RH).
    G12974992Courtesy of HYUNDAI MOTOR AMERICA

    [RH: Trip + Cruise] 

    Switch Connector Terminal Resistance ±(3%)
    Cancel 1 - 6 390Ω
    SET - 610Ω
    RES + 910Ω
    Cruise ON/OFF 1.38 kΩ
    Speed Limiter 2.13 kΩ
    SCC ON/OFF 3.63 kΩ
    Trip 390Ω
    Trip GROUP
    Trip UP 610Ω
    Trip DOWN 910 kΩ
    Trip RESET 1.38 kΩ
    Trip OK
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.