2020 Hyundai Elantra Value EditionFACTORY OEM SERVICE PROCEDURE

Connector Pin Information

WARNING: This page is about a different car, the 2019 Hyundai Elantra. However, it is still accessible from the selected car via links, so may be relevant.
No Connector A (Int AMP) Connector A (Ext AMP) Connector B Connector C
1 Rear left speaker (+) - - Body CAN (HI)
2 Rear left speaker (-) - MIC Signal (+) Chassis CAN (HI)
3 - AMP Navi Voice (+) - -
4 - AMP SPDIF (HI) - -
5 - - Antenna Power -
6 Camera Power Camera Power ILL (+) -
7 Camera Video Camera Video MM CAN (HI) -
8 - - - Body CAN (LOW)
9 - - - Chassis CAN (LOW)
10 AUX Audio (RH) AUX Audio (RH) B+ -
11 AUX Detect AUX Detect B+ -
12 Steering wheel remote Steering wheel remote GND -
13 Front lift speaker (+) - GND -
14 Front lift speaker (-) - MIC GND -
15 Front right speaker (-) - MIC Signal (-) -
16 Front right speaker (+) - - MTS Key
17 - AMP Navi Voice (-) - -
18 - AMP SPDIF (LOW) - -
19 - AMP SPDIF GND - -
20 Camera Power GND Camera Power GND MM CAN (LOW) -
21 Camera Video GND Camera Video GND - -
22 - - ACC Β 
23 - - -
24 AUX Audio (LH) AUX Audio (LH) -
25 AUX Audio GDN AUX Audio GDN -
26 Steering wheel remote GND Steering wheel remote GND -
27 Rear right speaker (-) - -
28 Rear right speaker (+) - -
29 - - -
30 - - -
31 - - -
32 - - -
33 - - IGN 1
34 - - -
35 - - -
36 - - Β 
37 - -
38 Speed Speed
USB Connector PIN Description PIN Description
G12974975Courtesy of HYUNDAI MOTOR AMERICA
1 USB VOD 5V 3 USB (+)
2 USB (-) 4 USBGND
GPS Antenna PIN Description PIN Description
G12974976Courtesy of HYUNDAI MOTOR AMERICA
1 Signal 2 GND
Ridio Antenna PIN Description PIN Description
G12974977Courtesy of HYUNDAI MOTOR AMERICA
1 FM1/AM 2 -
SXM Antenna PIN Description PIN Description
G12974978Courtesy of HYUNDAI MOTOR AMERICA
1 Signal 2 Ground
LTE (Main) Antenna (USA) PIN Description PIN Description
G12974979Courtesy of HYUNDAI MOTOR AMERICA
1 Signal 2 Ground
LTE (Div) Antenna (USA) PIN Description PIN Description
G12974980Courtesy of HYUNDAI MOTOR AMERICA
1 Signal 2 Ground
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.