2018 Hyundai Sonata Plug-In HybridFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Remove the air cleaner assembly and air duct. (Refer to "AIR CLEANER ")
  2. Remove the Hybrid Power Control Unit(HPCU) assembly.

    (Refer to "HPCU ")

  3. Remove the under cover. (Refer to "ENGINE ROOM UNDER COVER ")
  4. Remove the valve body assembly. (Refer to "VALVE BODY ")
  5. Disconnect the input/output speed sensor connector(A).
  6. Remove the solenoid valve connector assembly after removing bolts(B).
    G12793460Courtesy of HYUNDAI MOTOR AMERICA
  7. Disconnect the main connector(A).
    1. Press the lock
    2. Raise the lever
      G12793461Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the clip(A) after removing the bolt.
    G12793462Courtesy of HYUNDAI MOTOR AMERICA
  9. Disconnect the main connector(A) from the transaxle.
    G12793463Courtesy of HYUNDAI MOTOR AMERICA
    CAUTION:
    • Replace the O-Ring(A) before reinstalling the main connector.
    G12793464Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.