2018 Hyundai Sonata Plug-In HybridFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Air cleaner assembly and air duct.

    (Refer to "AIR CLEANER ")

  2. Battery and battery tray.

    (Refer to "AUXILIARY 12V BATTERY ")

  3. Remove the nut (A) from the manual control lever.
  4. Remove the shift cable (B) from the bracket (C) at transaxle side.
    G12793549Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the floor console assembly.

    (Refer to "FLOOR CONSOLE ")

  6. Remove the air duct (A).
    G12793550Courtesy of HYUNDAI MOTOR AMERICA
  7. Remove the snap pin (A).
    G12793551Courtesy of HYUNDAI MOTOR AMERICA
  8. Disconnect the cable eye end (B) from the shift lever.
  9. Disconnect the cable socket (C) from the shift lever.
    G12793552Courtesy of HYUNDAI MOTOR AMERICA
  10. Remove the airbag module.

    (Refer to "AIRBAG MODULE ")

  11. Disconnect the shift cable retainer (B) after removing the mounting nut (A).
  12. Remove the shift cable by pulling it toward the interior.
    G12793553Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.