2018 Hyundai Santa Fe XL BaseFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Remove the floor console.

    (Refer to "FLOOR CONSOLE ")

  2. Remove the air duct.
  3. Disconnect the sports mode connector (A).
    G12034388Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the shift cable (A).
    G12034389Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the shift lever assembly (A) by removing the bolts (C-4ea).

    Tightening torque:Β 

    8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

    G12034390Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.