2018 Hyundai Santa Fe XL BaseFACTORY OEM SERVICE PROCEDURE

TCM Terminal Function

CONNECTOR DESCRIPTION (A)

Pin Description
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8 -
9 -
10 CAN communication line (HIGH)
11 -
12 -
13 -
14 -
15 -
16 -
17 -
18 -
19 -
20 -
21 -
22 -
23 -
24 -
25 -
26 -
27 Ignition switch
28 -
29 Sports mode up switch
30 -
31 -
32 -
33 -
34 -
35 CAN communication line Low
36 -
37 -
38 -
39 -
40 -
41 -
42 -
43 -
44 Inhibitor switch signal "S1"
45 Inhibitor switch signal "S2"
46 Inhibitor switch signal "S3"
47 Inhibitor switch signal "S4"
48 -
49 -
50 -
51 -
52 -
53 -
54 Sports mode down switch
55 -
56 -
57 -
58 -
59 -
60 -
61 -
62 -
63 -
64 -
65 -
66 -
67 -
68 -
69 -
70 -
71 -
72 -
73 -
74 -
75 -
76 -
77 -
78 -
79 Sports mode Select switch
80 -
81 -
82 -
83 -
84 Shift lock solenoid
85 Reverse lamp relay
86 P/N relay
87 -
88 -
CONNECTOR DESCRIPTION (B)

Pin Description Pin Description
1 Overdrive clutch control solenoid valve (VFS) 52 Underdrive brake control solenoid valve (VFS)
3 Input speed sensor signal 53 SS-B Solenoid valve (ON/OFF)
4 Output speed sensor signal 54 Output speed sensor power
26 Torque converter control solenoid valve (VFS) 55 Oil temperature sensor (-)
27 35R Clutch control solenoid valve (VFS) 57 Oil temperature sensor (+)
28 SS-A Solenoid valve (ON/OFF) 76 Solenoid valve power 1
29 Input speed sensor power 77 Solenoid valve power 2
51 Line pressure control solenoid valve (VFS) 78 26 Brake control solenoid valve (VFS)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.