2018 Hyundai Santa Fe XL BaseFACTORY OEM SERVICE PROCEDURE

Adjusting Method For T/M Control Cable

  1. Set room side shift lever and T/M side manual control lever to "N" position.
  2. Connect room side shift lever and shift cable.
  3. Push cable to "F" direction shown to eliminate FREE PLAY.
  4. Tighten adjusting nut (A).

    Tightening torque:Β 

    7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

    G12034395Courtesy of HYUNDAI MOTOR AMERICA
  5. After adjusting according check to be sure that this part operates surely at each range of T/M side corresponding to each position of shift lever.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.