2018 Hyundai Santa Fe XL BaseFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

WARNING:
  • Don't remove the camshaft position sensor while the engine is running or right after engine is turned off. The part and engine oil is hot and can cause burns.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the camshaft position sensor connector (A).
  3. Remove the installation bolt (B), and then vertically remove the sensor from the cylinder head.

    Bank 1/Intake 

    Fig 1: Locating Camshaft Position Sensor Connector And Installation Bolt (Bank 1 Or Intake)
    G12034011Courtesy of HYUNDAI MOTOR AMERICA

    Bank 1/Exhaust 

    Fig 2: Locating Camshaft Position Sensor Connector And Installation Bolt (Bank 1 Or Exhaust)
    G12034012Courtesy of HYUNDAI MOTOR AMERICA

    Bank 2/Intake 

    Fig 3: Locating Camshaft Position Sensor Connector And Installation Bolt (Bank 2 Or Intake)
    G12034013Courtesy of HYUNDAI MOTOR AMERICA

    Bank 2/Exhaust 

    Fig 4: Locating Camshaft Position Sensor Connector And Installation Bolt (Bank 2 Or Exhaust)
    G12034014Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.