2018 Hyundai Santa Fe XL BaseFACTORY OEM SERVICE PROCEDURE

CVVT Oil Control Valve (Exhaust)

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the CVVT oil control valve connector (A).

    Bank 1Β 

    Fig 1: Locating CVVT Oil Control Valve Connector (Bank 1)
    G12034070Courtesy of HYUNDAI MOTOR AMERICA

    Bank 2Β 

    Fig 2: Locating CVVT Oil Control Valve Connector (Bank 2)
    G12034071Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the cylinder head cover.

    (Refer to "CYLINDER HEAD COVER ")

  4. Remove the installation bolt (A), and then remove the valve from the engine.

    Bank 1Β 

    Fig 3: Locating Installation Bolt (Bank 1)
    G12034072Courtesy of HYUNDAI MOTOR AMERICA

    Bank 2Β 

    Fig 4: Locating Installation Bolt (Bank 2)
    G12034073Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.