2018 Hyundai Santa Fe XL BaseFACTORY OEM SERVICE PROCEDURE

Programming the Max. T/Gate Opening (Garage Position)

  1. The customized Programmed Basic Position is set equal to the Maximum Basic Position after the Learned Mechanical End Position is learned.
    • The customer can change the Programmed Basic Position to any new position between the Maximum Point For Closing and the Maximum Basic Position.
    • If the customer wants to set a new Programmed Basic Position below the actual Programmed Basic Position, he has to move the liftgate electrically or manually to the new position and has to push the Inner Switch for e.g. 3 seconds (time can be modified by parameter)
    • If the customer wants to set a new Programmed Basic Position above the actual Programmed Basic Position he has to move the liftgate manually to the new position and has to push the Inner Switch for 5 seconds (time can be modified by parameter)
    • If the user tries to program a liftgate position above the Maximum Basic Position, the ECU will set the Programmed Basic Position to the Maximum Basic Position.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.