Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Learned/Calculated/Programmed Positions
- Maximum Point for Opening
Above this position a start in opening direction could make the liftgate move beyond the Maximum Basic Position and overload the mechanical system (hinges).
Therefore the start of an opening action above this point is disabled.
Anyway the liftgate moves beyond this point, if it has been started at a lower position.
- Learned Mechanical End Position
This is the mechanical block position while opening and is considered to be 100% opening. During the first liftgate opening this position is learned.
After learning, the liftgate will not move beyond the Maximum Basic Position, which is defined by the Learned Mechanical Position - Security Distance.
All positions are defined by parameters in the ECU or programmed by the user (Basic Programmed Position)
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
