2018 Hyundai Ioniq Plug-In Hybrid LimitedFACTORY OEM SERVICE PROCEDURE

[In The Case Of Installing Used ECM]

  1. Perform "ECM NEUTRAL MODE " procedure with GDS.

    (Refer to "IMMOBILIZER SYSTEM DIAGNOSIS (PHEV) ")

  2. After finishing "ECM NEUTRAL MODE ", perform "TEACHING MODE PROCEDURE DESCRIPTION (STEP BY STEP) " procedure with GDS.

    (Refer to "IMMOBILIZER SYSTEM DIAGNOSIS (PHEV) ")



  1. Perform "ECM NEUTRAL MODE " procedure with GDS.

    (Refer to "SMART KEY ")

  2. After finishing "ECM NEUTRAL MODE ", insert the key (or press the start button) and turn it to the IGN ON and OFF position. Then the ECM learns the smart key information automatically.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.