2018 Hyundai Elantra LimitedFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the steering wheel assembly.

    (Refer to Steering System - "STEERING WHEEL ")

  3. Remove the steering back cover (A).
    Fig 1: Locating Steering Back Cover
    G12023314Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the steering remote control connector (A).
    Fig 2: Locating Steering Remote Control Connector
    G12023315Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the steering remote control after loosening the screws.
    Fig 3: Steering Remote Control Screws
    G12023316Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.