2018 Hyundai Elantra LimitedFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Inspection

  1. Check for resistance between terminals in each switch position (LH).
    Fig 1: Checking For Resistance Between Terminals In Each Switch Position (LH)
    G12023312Courtesy of HYUNDAI MOTOR AMERICA

    [LH: Audio + Hands free] 

    Switch Connector terminal Resistance (±5%)
    SEEK Up 2-5 430 Ω
    SEEK Down 1.11 kΩ
    MODE 2.11 kΩ
    MUTE 3.11 kΩ
    Volume (+) 4.61 kΩ
    Volume (-) 6.81 kΩ
    Voice 10.71 kΩ
    SEND 18.91 kΩ
    END 40.91 kΩ
  2. Check for resistance between terminals in each switch position (RH).
Fig 2: Checking For Resistance Between Terminals In Each Switch Position (RH)
G12023313Courtesy of HYUNDAI MOTOR AMERICA

[RH: Trip + Cruise] 

Switch Connector terminal Resistance (±5%)
Cancel 2-5 330 Ω
SET - 550 Ω
RES + 880 Ω
Cruise ON/OFF 1.44 kΩ
Group 3-5 550 Ω
Trip Up 880 Ω
Trip Down 1.44 kΩ
ENTER 2.54 kΩ
SCC ON/OFF 5.54 kΩ
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.