2017 Hyundai Veloster Base, Standard TransFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the driver airbag module.

    (Refer to DRIVER AIRBAG (DAB) MODULE AND CLOCK SPRING )

  3. Remove the steering wheel.

    (Refer to STEERING WHEEL )

  4. Remove the steering wheel cover (A) after loosening 4 screws.
    Fig 1: Removing Steering Wheel Cover Screws
    G12126190Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the steering wheel remote control switches connectors.

    LH-Audio/Bluetooth + Voice 

    Fig 2: Locating Steering Wheel Remote Control Switches Connectors (LH)
    G12126191Courtesy of HYUNDAI MOTOR AMERICA

    RH-Cruise/Trip + Reset 

    Fig 3: Locating Steering Wheel Remote Control Switches Connectors (RH)
    G12126192Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the wiring and loosen 5 screws.
  7. Remove the steering wheel remote control switch assembly (A).
    Fig 4: Removing Steering Wheel Remote Control Switch Assembly
    G12126193Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the bluetooth switch and the trip switch (A) after loosening the screws.
    Fig 5: Removing Bluetooth Switch & Trip Switch Screws
    G12126194Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.