2017 Hyundai Sonata Plug-In HybridFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Air cleaner assembly and air duct. (Refer to Engine Mechanical System - "Air Cleaner ")
  2. Battery and battery tray. (Refer to COMPONENTS )
  3. Remove the nut (A) from the manual control lever.
  4. Remove the shift cable (B) from the bracket (C) at transaxle side.
    Fig 1: Locating Shift Lever Components
    G11631382Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the floor console assembly. (Refer to Body - "Floor Console ")
  6. Remove the air duct (A).
    Fig 2: Shift Lever Air Duct
    G11631383Courtesy of HYUNDAI MOTOR AMERICA
  7. Disconnect the shift cable (A).
    1. Disconnect the cable bracket from the shift lever after pushing the lock.
    2. Disconnect the cable holer (A) from the shift lever.
    Fig 3: Disconnecting Shift Cable
    G11631384Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the airbag module. (Refer to Restraint - "Airbag Module ")
  9. Disconnect the shift cable retainer (B) after removing the mounting nut (A).
  10. Remove the shift cable by pulling it toward the interior.
    Fig 4: Locating Shift Cable Retainer And Mounting Nut
    G11631385Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.