SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2017SANTA FE SE, FWDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM DIAGNOSIS (2 OF 3)DTC P0335: CRANKSHAFT POSITION SENSOR 'A' CIRCUITDTC INSPECTIONDTC DETECTING CONDITION
2017 Hyundai Santa Fe SE, FWD

DTC Inspection: DTC Detecting Condition

2017 Hyundai Santa Fe SE, FWDSECTION DTC Detecting Condition
DTC DETECTING CONDITIONS AND POSSIBLE CAUSES

Item Detecting Condition Possible Cause
DTC Strategy
  • Check reference wave during cranking
  1. Poor connection
  2. Open in harness
  3. CKP sensor
  4. PCM
Enable Conditions
  • IG "ON", Cranking or engine-off during driving
  • No DTC related to CAM
  • Camshaft position sensor state change
Threshold value
  • No reference signal over 0.15 sec.
Diagnosis Time
  • 0.15 sec.
MIL On Condition
  • 2 Drive Cycles
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.