Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Hyundai Azera BaseFACTORY OEM SERVICE PROCEDURE
Repair Procedures: Removal
- Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line ")
- Remove the fuel pump service cover (A) in the trunk.
- Disconnect the fuel pump connector (A) and the fuel tank pressure sensor connector (B).
- Disconnect the fuel feed tube quick connector (C).
- Lift the vehicle and support the fuel tank with a jack.
- Remove the center muffler assembly.
(Refer to Engine Mechanical System - "CENTER MUFFLER ")
- Disconnect the fuel filler hose (A).
- Disconnect the vapor hose quick-connector (A).
- Remove the parking brake line (A).
- Remove the fuel tank band installation nuts (A).
- Remove the fuel tank after removing the fuel tank band (A) as below.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.