2017 Hyundai Azera BaseFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Release the residual pressure in fuel line.

    (Refer to Fuel Delivery System - "Release Residual Pressure in Fuel LineΒ ")

  2. Remove the fuel pump service cover (A) in the trunk.
    Fig 1: Removing Fuel Pump Service Cover In Trunk
    G12088583Courtesy of HYUNDAI MOTOR AMERICA
  3. Disconnect the fuel pump connector (A) and the fuel tank pressure sensor connector (B).
  4. Disconnect the fuel feed tube quick connector (C).
  5. Remove the fuel pump plate cover (D) after removing the bolts.
    Fig 2: Disconnecting Fuel Pump Connector And Fuel Tank Pressure Sensor Connector
    G12088584Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the fuel pump from the fuel tank.
    Fig 3: Removing Fuel Pump From Fuel Tank
    G12088585Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.