Function Of Safety Power Window: Notes

When driver door power window auto-up switch is operated, safety function is activated.

1. Safety function condition

   When detect the force of 100N (using the 10N/mm spring) during the window rising, window is reversed.

2. Length of window reversing (except holding the auto-up switch)
   • When detect the jamming during the 4mm ~ 250mm from top of the door.

     → Window is reversed until 300mm from top of the door.

     Fig 1: Checking Window Reversing Length (Except Holding Auto-Up Switch)

     Courtesy of HYUNDAI MOTOR AMERICA
   • When detect the jamming over the 250mm from top of the door.

     → Window is reversed until 20mm from jamming position.

     Fig 2: Checking Window Reversing Length (Jamming Position)

     Courtesy of HYUNDAI MOTOR AMERICA
3. Length of window reversing (holding the auto-up switch)
   • When detect the jamming during holding the auto-up switch.

     → Window is reverse until 25mm from jamming position.

   • Auto-up function is not available during the 5 seconds from above condition.

     → When holding the auto-up switch, window is operated as a manual-up function. (Safety function is not activated.)

   • When holding the auto-up switch after 5 seconds from above condition.

     → Window is reverse until 25mm from jamming position.

     Fig 3: Checking Window Reversing Length (Holding Auto-Up Switch)

     Courtesy of HYUNDAI MOTOR AMERICA
4. Safety function is not available area

   Safety function is not available during the 4mm from top of the door.