Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Control Specification
- MANUAL Operation
- MANUAL Seat Operation SEAT is to be operated by MANUAL switch Input of SEAT. SLIDE, RECLINE, Front height, and cushion extension is available to operate manually with IGN2 ON regardless of ECU B+ OFF.
- MEMORY Saving Operation
- Allowing for Memory Storage
This process is allowed in case that IGN2 switch = ON, "P" Position switch = ON and SPEED input is high (less than 3 km/h).
1 BUZZER output is generated from IMS by receiving the DATA, "SET = 1."
- Memory Saving Operation
When MEM_1 or MEM_2 of transmitted CAN communication DATA receives the DATA ("1") by IMS switch generated from 1 or 2 switch control in memory storage permission mode above, 2 BUZZER outputs are generated and current seat position is stored. (IMS switch transmits storage command only if 1 or 2 switch input is generated within 5 seconds from SET switch OFF->ON, and the storage permission mode is cancelled if more than 5 seconds are elapsed.)
- Requirements for Memory Storage
MEMORY Storage is not allowed or cancelled in case that all of the following requirements are not met.
- Ignition switch is ON
- "P" Position switch is ON
- Vehicle speed input received from IPM is high (less than 3 Km/h)
- Less than 5 seconds elapsed from SET switch OFF->ON (determined by IMS switch)
- Memory SET is to be available for memory storage not with standing the number of SET times. (However, each MEMORY switch operation delivers 1 memory storage action only.)
- If MEMORY command is received during operating easy access function or reproducing memory, activation is stopped, and current position is stored.
If the command is received during operating MANUAL switch of SEAT, it will be stored where the memory command is received.
- Allowing for Memory Storage
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.